Avaya J100 Series Installing And Administering page 247

Parameter
SCA<n>_ENABLED
SCA<n>_MAX_CALL_
APPEARANCES
SCA<n>_SIPUSERID
SCA<n>_USERNAME
April 2020
Default Description
value
0 Specifies whether <n> shared line is enabled. <n> can be a
number of 1 to 8.
Value operation:
• 0: Indicates disabled.
• 1: Indicates enabled.
1 Specifies the maximum number of simultaneous calls on each
specified shared line on BroadSoft server. <n> can be a number
of 1 to 8 for SCA mode.
This set of parameters provides independent control of the
maximum number of call sessions on each shared line. This
setting directly maps to the number of shared call appearances
that are be displayed on the phone for this shared line.
Values ranges from 1 to 5.
Null Specifies the Address or Record (AOR) for each shared line.
This parameter is required for both the SCA and BLA modes.
<n> can be a number of 1 to 8.
This parameter should only specify the handle, as the domain is
specified independently.
Null Specifies the user name to be used for authentication when
challenged with 401 for credentials on SIP requests associated
with the shared line. <n> can be a number of 1 to 8.
Installing and Administering Avaya J100 series IP Phones in an Open SIP
Comments on this document? infodev@avaya.com
Note:
Ring Central Server supports only 1 call appearance for
each shared line. Even if the value is set otherwise, the
server ignores it.
Note:
Shared lines are only supported for the same SIP domain
as the primary line.
Note:
This value is optional in SCA. If not provided,
SCA<n>_SIPUSERID value will be used. In BLA mode, The
Ring Central Server ignores this parameter and uses
primary authentication credentials instead.
environment
Feature configuration
Table continues...
247