Kohler K-3900X-2 Installation Manual page 10

Determine Mounting Block Location (cont.)
Insert a pencil into the holes in the mounting blocks and mark the center of the holes after positioning the
¨
mounting block.
Remove the mounting blocks.
¨
Position a mounting block in the area indicated on the right side of the template. Align the outside edge of
¨
the mounting blocks with the inside line. Then move parallel 2 mm to the inside.
Insert a pencil into the holes in the mounting blocks and mark the center of the holes after positioning the
¨
mounting block.
At the locations where the centerline in the slots marked on the template and the pencil mark indicating
¨
the hole locations meet, drill a 13 mm hole if anchors will be used.
If anchors will be used, insert one of the supplied anchors in each of the holes.
¨
Remove the template.
¨
Install the Floor Flange
Position floor flange on the floor. Mark three anchor holes on the floor with pencil.
¨
Drill 10 mm anchor holes. Insert the anchors.
¨
Place the gasket under the floor flange. Position floor flange on the floor.
¨
Tighten the screws.
¨
1195109-X2-A
Floor Flange
Gasket
10 Kohler Co.