Front Brake Master Cylinder - Suzuki LT-Z250K4 Setup Manual

FRONT/AVANT
ASSEMBLY
HANDLEBARS
Loosen the handlebar clamp bolts.
A: Handlebar clamp bolt
NOTE:
Align the dot mark on the handlebars with the
mating surface of the front side of left clamp.
A: Handlebars
B: Clamp (Upper)
C: Clamp (Lower)
D: Flange bolt
E: Dot mark
Tighten the handlebar clamp bolts to the specified torque.
NOTE:
To install the handlebars correctly, first
A A A A of the front side with speci-
tighten the bolt
fied torque and then tighten the bolt
rear side.
!
Make sure that the clamp has no clearance at
the front side as shown in the illustration.
" Handlebar clamp bolt: 23 N·m (2.3 kgf-m) " " "
A: Flange bolt
B: Flange bolt

FRONT BRAKE MASTER CYLINDER

Remove the bolts and holder from the front brake
master cylinder.
A: Master cylinder
B: Bolt
C: Holder
7
B B B B of the
C: Dot mark