Front Suspension; Tire Pressure; Headlight Beam Adjustment - Suzuki LT-Z250K4 Setup Manual

1
2
3
4
5

FRONT SUSPENSION

Make sure the spring setting of the front suspension
is correct.
The standard setting for this vehicle is as indicated in
the table below.
Standard setting
#
When adjusting either of the suspensions, be
sure to adjust both the right and left springs to
the same preload setting.
A: Adjuster

TIRE PRESSURE

Using an accurate air gauge, check the air pressure
of the front and rear tires. The pressure should be as
shown.
COLD INFLATION TIRE PRESSURE
LOAD
FRONT
30 kPa
Up to 110 kg
0.30 kg/cm
243 lbs
4.4 psi

HEADLIGHT BEAM ADJUSTMENT

The headlight beam can be adjusted vertically if nec-
essary.
To adjust the beam vertically:
Loosen the headlight fitting bolts and move the head-
light up or down as required.
Tighten the bolts.
A: Bolt
B: Headlight
37
Position 2
TIRE PRESSURE
REAR
25 kPa
2 2
0.25 kg/cm
3.6 psi