Front Brake Master Cylinder - Suzuki LT-R450K6 Setup Manual

FORWARD
Tighten the handlebar clamp bolts to the specified
torque.
Handlebar clamp bolt: 26 N·m (2.6 kgf-m)
NOTE:
To install the handlebars correctly, first tighten
the bolt A of the front side with specified
torque and then tighten the bolt B of the rear
side.
Make sure that the clamp has no clearance at
the front side as shown in the illustration.
A: Flange bolt
B: Flange bolt
C: Dot mark

FRONT BRAKE MASTER CYLINDER

Install the front brake master cylinder onto the handle-
bars.
Align the dot mark on the handlebars with the master
cylinder-to-holder fitting surface.
Tighten the master cylinder mounting bolts to the
specified torque.
Front brake master cylinder mounting bolt:
NOTE:
To install the holder correctly, first tighten the
bolt C of the upper side with specified torque
and then tighten the bolt D of the lower side.
A: Holder
B: Front brake master cylinder
C: 6 × 25 mm flange bolt
D: 6 × 25 mm flange bolt
E: Dot mark
NOTE:
Install the holder in position according to the
mark "UP".
Make sure that the holder has no clearance at
the upper side as shown.
Check for brake fluid leakage.
A: Bolt
B: Holder
C: Master cylinder
D: Handlebars
6
10 N·m (1.0 kgf-m)