Suzuki LT-Z250K4 Setup Manual page 26

NOTE:
If no air bubbles are coming up from a filler
port, tap the bottom of the container two or
three times. Never remove the container from
the battery.
After confirming that the electrolyte has entered the
battery completely, remove the electrolyte containers
from the battery. Wait for around 20 minutes.
Insert the caps into the filler holes, pressing in firmly
so that the top of the each caps does not protrude
above the upper surface of the battery's top cover.
A: Caps
!
Never use anything except the specified bat-
tery electrolyte.
Once the sealing cap has been installed in the
battery, do not remove the sealing cap.
Charge the battery with a battery charger.
!
For charging the battery, make sure to use the
charger specially designed for MF battery.
Otherwise, the battery may be overcharged
resulting in shortened service life.
Do not remove the cap during charging.
Position the battery with the cap facing
upward during charging.
After charging the battery, install the battery in the
vehicle as follows.
!
When attaching the wiring harness battery
leads to the battery terminals, observe the cor-
rect polarity.
NOTE:
The terminal bolts and nuts are attached to the
battery.
25