Suspension Mounted - Taiden TES-5604 Series Installation And Operating Manual

2.3.5 Suspension mounted

Mounting steps:
Step 1: Use the suspension as a template to mark 2 mounting holes locations on the diagonal. Insert M6 wedge concrete
anchor into each hole until it flush with the concrete surface;
Step 2: Loop the safety rope around the M6 wedge concrete anchors as shown. route the opposite end of the safety rope
through the hole on the suspension as shown;
Step 3: Fix the suspension in the ceiling with the washer and nut of M6 wedge concrete anchor;
Step 4: Align the tapped holes on the top of TES-5685M to the mounting holes on the bottom plate of the suspension.
Insert and fully tighten 2 M6×30 mm bolts;
Step 5: Run the safety rope through the lock hole on TES-5685M and hook it back as shown.
Figure 2.10 Suspension mounted
17