Installer's Information; Locating Your Gas Fireplace; Unit Assembly Prior To Installation; Side And Back Standoff Assembly - Regency City ACV40E Series Owners & Installation Manual

Zero clearance direct vent gas fireplace

Hide thumbs

Table Of Contents

Table of Contents

Locating Your Gas Fireplace

1. When selecting a location for your fireplace,

ensure that the clearances are met.

2. The appliance must be installed on a flat, solid,

continuous surface For example a timber, metal

or concrete floor or in a raised (on the wall) ap-

plication. The appliance must be installed on a

metal or timber panel extending the full width

and depth of the appliance.

3. The ACV40E Direct Vent Gas Fireplace can be

installed in a recessed position or framed out

into the room as in A, B, C, D.

See Diagram 1.

A) Flat on Wall-ACV40E

B) Flat on Wall Corner-ACV40E

C) Recessed into Wall/Alcove-ACV40E

D) Corner-ACV40E

Diagram 1

4. For bedroom installations, check with local

codes before installation. This appliance is

offered with a remote control.

5. The ACV40E Direct Vent Gas Fireplace is ap-

proved for alcove installations, see "Clearances"

section for details.

6. We recommend that you plan your installa-

tion on paper using exact measurements for

clearances and floor protection before actually

installing this appliance. Have an authorized

inspector, dealer, or installer review your plans

before installation.

Note:

For vent terminations refer to "Exterior

Vent Termination Locations" section.

Unit Assembly Prior to Installation

Before you start

The ACV40E has 6 standoffs, 2 on each side and 2 at the back that need assembly before installation.

WARNING! Risk of Fire! Comply with all minimum clearances.

Side and Back Standoff Assembly

The standoffs are shipped in a flat position and must be folded into shape and attached.

Take each standoff off the unit by removing one screw and bend into the correct shape. Slot the 2 tabs

of the stand off into the slots in the unit and attach the other end with one screw.

Nailing Strips

Nailing strips are shipped folded flat against the unit.

Fold nailing strips out 90º before installing unit.

Secure nailing strips to framing using wood or

metal screws.