Siemens SIMATIC NET SCALANCE S615 Configuration Manual page 144

Configuring with Web Based Management
4.5 "System" menu
● Security
Specify whether transfer of the e-mail from the device to the SMTP server is encrypted. This
is only possible when the SMTP server supports the selected setting.
Note
2-factor authentication (2FA)
2-factor authentication is not supported.
– SSL/TLS
– StartTLS
– None: The e-mail is transferred unencrypted.
● Test
Sends a test e-mail to the configured recipients.
● Test Result
Shows whether the e-mail was sent successfully or not. If sending was not successful, the
message contains possible causes.
Procedure
Configuring the SMTP server
1. Enable the "SMTP Client" function.
2. Enter the IP address or the FQDN of the SMTP server for "SMTP Server Address".
3. Click the "Create" button. A new entry is generated in the table.
4. Enter the name of the sender that will be included in the e-mail for "Sender Email Address".
5. Enter the user name and password if the SMTP server prompts you to log in.
6. Under "Security", specify whether transfer to the SMTP server is encrypted.
7. Enable the SMTP server entry.
8. Click the "Set Values" button.
Note
Depending on the properties and configuration of the SMTP server, it may be necessary to
adapt the "Sender E-Mail Address" input for the e-mails. Check with the administrator of the
SMTP server.
144
SCALANCE S615 Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C388-08