Siemens SINUMERIK 840D sl Programming Manual page 354

Changes from cycle version SW4.4 and higher
A.4 Comparing GUD parameters (regarding measuring functions)
GUD up to Version 7.5 From MD/SD version V2.7/V4.4
E_MESS_D_R
E_MESS_FM
E_MESS_F
E_MESS_FZ
E_MESS_CAL_D[2]
E_MESS_CAL_L[0]
E_MESS_MT_DR[3]
E_MESS_MT_DIR[3]
E_MESS_SETT[0]
E_MESS_SETT[1]
1) For parameters SD54670 to 54677, there are two data sets, indices 0 and 1.
Note: Data set with index 1 should always be used for GIV 2.7/4.4. Data set with index 0 should always
be used from GIV 4.5 and higher.
GUD up to cycle SW
04.04.00
_RF
354
MD51753 $MNS_J_MEA_M_DIST_TOOL_RADIUS
SD55630 $SCS_MEA_FEED_MEASURE
MD51757 $MNS_J_MEA_COLL_MONIT_FEED
MD51758 $MNS_J_MEA_COLL_MONIT_POS_FEED
MD51770 $MNS_J_MEA_CAL_RING_DIAM[0...11]
MD51772 $MNS_J_MEA_CAL_HEIGHT_FEEDAX[0...11]
MD51780 $MNS_J_MEA_T_PROBE_DIAM_RAD[0...5]
MD51784 $MNS_J_MEA_T_PROBE_APPR_AX_DIR[0...5]
SD55740 $SCS_MEA_FUNCTION_MASK bit 14
SD55740 $SCS_MEA_FUNCTION_MASK bit 15
From cycle SW 04.04.05.00
N55640 $SCS_MEA_FEED_CIRCLE
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Measuring cycles