Calling The Measuring Version; Parameters - Siemens SINUMERIK 840D sl Programming Manual

Measuring variants
3.3 Measure workpiece (milling)
3.3.2.2

Calling the measuring version

Procedure
The part program or ShopMill program to be processed has been created and you are in the
editor.
3.3.2.3

Parameters

Parameters
G code program
Parameters Description
PL Measuring plane (G17 - G19)
Calibration data set (1 - 40)
F Calibration and measuring fee‐
drate
Parameters Description
Adapt tool length
● Yes (adapt probe length and trigger point)
● No (adapt trigger point only)
Measuring direc‐ Measuring axis (+/-) Z (for measuring plane G17)
tion
Z0 Reference point Z (for measuring plane G17)
DFA Measurement path
TSA Safe area for the measurement result
Measurements Number of measurements at the same location (1-9)
The "Adapt tool length" parameter is only available when this field has been enabled via SD 54780
1)
$SNS_J_MEA_FUNCTION_MASK_PIECE bit 28.
110
1. Press the "Meas. workpiece" softkey.
2. Press the "Calibrate probe" softkey.
3. Press the "Length" softkey.
The input window "Calibrate: Length at edge" opens.
ShopMill program
Unit Parameters Description
- T
- D
Distance/
min
F
X
Y
Z
1)
Name of the probe
Cutting edge number (1 - 9)
Calibration data set (1 - 40)
Calibration and measuring fee‐
drate
Start point X of the measurement mm
Start point Y of the measurement mm
Start point Z of the measurement mm
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Unit
-
-
-
mm/min
Unit
-
-
mm
mm
mm
-
Measuring cycles