Siemens SINUMERIK 840D sl Programming Manual page 271

Parameters
SPOS
SCOR
DFA
TSA
TZL
TDIF
Measuring variant, milling on the turning machine
Procedure
The part program or ShopMill program to be edited has been created and you are in the editor.
Parameter
ShopMill program
Parameter Description
T Name of the probe
D Cutting edge number (1 - 9)
Calibration data set (1 - 6)
F Calibration and measuring fee‐
drate
X Start point X of the measurement mm
Y Start point Y of the measurement mm
Z Start point Z of the measurement mm
List of the result parameters
The measuring variant "Milling tool" provides the following result parameters:
Table 3-43
Parameters
_OVR[8]
_OVR[9]
_OVR[10]
_OVR[11]
_OVR[12]
_OVR[13]
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Description
Angle for positioning on a tool tip (only for milling cutter reversal "Yes" or position
spindle "Yes" or for "complete" measurement type)
Offset angle for reversal (only for milling tool reversal "Yes")
Measurement path
Safe area for the measurement result
Tolerance range for work offset
Tolerance range for dimensional difference monitoring
1. Press the "Meas. tool" softkey.
2. Press the "Milling tool" softkey.
"Milling tool" result parameters
Description
Length actual value L1
Length difference L1
Length actual value L2
Length difference L2
Radius actual value
Radius difference
Unit
-
-
-
mm/min
Measuring variants
3.5 Measure tool (turning)
Unit
Degrees
Degrees
mm
mm
mm
mm
Unit
mm
mm
mm
mm
mm
mm
271