Removal And Replacement Of Gear Motor - Hoshizaki F-330BAH Service Manual

16) Replace the removed parts in the reverse order of which they were removed.
If applicable, make sure the safety switch components are in position.
17) Move the flush/control switch to the "ICE" position. Plug the appliance into the electrical
outlet, then move the power switch to the "ON" position.
18) Replace the panels in their correct positions.

7. Removal and Replacement of Gear Motor

1) Remove the front panel. Move the flush/control switch to the "FLUSH" or "DRAIN"
position.
2) After 2 min., move the power switch to the "OFF" position, then unplug the appliance
from the electrical outlet.
3) Remove the top panel and top insulation panel.
4) Remove the thumbscrews attaching spout (B) to the bin, then remove spout (B).
See Fig. 3.
5) Remove the thumbscrews attaching spout (A) and safety bracket (A) (if applicable) to
the evaporator assembly, then remove spout (A) and safety bracket (A) (if applicable).
6) Remove the socket head cap screws securing the lower housing to the gear motor. Lift
the evaporator up slightly.
7) Remove the socket head cap screws securing the gear motor.
8) Remove the wiring from the gear motor, then remove the gear motor.
9) Attach spline coupling from the old gear motor to the new gear motor.
10) Replace the removed parts in the reverse order of which they were removed.
If applicable, make sure safety switch components are in position.
11) Move the flush/control switch to the "ICE" position. Plug the appliance into the electrical
outlet, then move the power switch to the "ON" position.
12) Replace the panels in their correct positions.
37