Removal And Replacement Of Gear Motor - Hoshizaki C101BAHA Service Manual

28) Replace the upper rear panel and top panel in their correct positions.
29) Plug the appliance into the electrical outlet, then move the control switch to the "ICE"
position to start the automatic icemaking process.

6. Removal and Replacement of Gear Motor

NOTICE! Hoshizaki recommends that the gear motor capacitor be replaced at the
same time as the gear motor.
1) Close the water supply line shut-off valve.
2) Move the control switch to the "DRAIN" position.
3) Allow the water system to drain for 1 minute.
4) After all of the water has drained, move the control switch to the "OFF" position, then
unplug the appliance from the electrical outlet.
5) Remove all ice from the storage bin.
6) Remove the top panel and upper rear panel. See Fig. 4.
7) Remove the bolts securing the lower housing to the gear motor. Lift the evaporator up
slightly.
8) Remove the bolts securing the gear motor.
9) Disconnect the gear motor wires, then remove the gear motor.
10) Attach the spline coupling from the old gear motor to the new gear motor.
11) Install the new gear motor.
12) Lower the evaporator onto the gear motor. Secure the lower housing to the gear motor.
13) Reconnect the electrical wires.
14) Open the water supply line shut-off valve.
15) Plug the appliance into the electrical outlet, then move the control switch to the "ICE"
position to start the automatic icemaking process.
16) Once the appliance starts to produce ice, check for water leaks.
17) Move the control switch to the "OFF" position, then unplug the appliance from the
electrical outlet.
18) Pour warm water into the storage bin and melt the ice. Clean the storage bin liner using
a neutral cleaner. Rinse thoroughly after cleaning.
19) Replace the upper rear panel and top panel in their correct positions.
20) Plug the appliance into the electrical outlet, then move the control switch to the "ICE"
position to start the automatic icemaking process.
32