Component Service Information - Hoshizaki F-330BAH Service Manual

B. Component Service Information
• When replacing a component listed below, see the notes to help ensure proper
operation.
• When replacing evaporator assembly and water circuit components, make sure
there are no water leaks after the repair is complete.
Component
Compressor • Install a new drier, start capacitor, and start relay.
Upper and • Inspect the upper bearing for wear. See "IV.B.1. Upper Bearing Wear Check." Replace if
Lower Bearings necessary.
• When replacing the upper bearing it is advised to also change the lower bearing at the
same time.
Evaporator • Install a new drier.
• Inspect the mechanical seal and O-ring prior to installing the new evaporator. If worn,
cracked, or scratched, the mechanical seal should also be replaced.
Gear Motor • Install a new gear motor capacitor.
NOTICE
Notes
29