Removal And Replacement Of Auger - Hoshizaki F-330BAH Service Manual

4. Removal and Replacement of Auger

1) Remove the front panel, then move the flush/control switch to the "FLUSH" or "DRAIN"
position.
2) After 2 min., move the power switch to the "OFF" position, then unplug the appliance
from the electrical outlet.
3) Remove the top panel and top insulation panel.
4) Remove the thumbscrews attaching spout (B) to the bin, then remove spout (B).
See Fig. 3.
5) Remove the thumbscrews attaching spout (A) and safety bracket (A) (if applicable) to
the evaporator assembly, then remove spout (A) and safety bracket (A) (if applicable).
See Fig. 3.
6) Loosen the cutter with a wrench.
7) Remove the seal bolts securing the extruding head. Using the cutter, lift out the auger
assembly.
8) Remove the cutter and extruding head from the auger and place them on the new
auger.
9) Install the new auger assembly. NOTICE! Seal bolts must be replaced once removed
because seal material is one-time use only. Loctite 243 must be applied to seal
bolt threads when seal bolts are replaced. Tighten seal bolts to
11.1 ft-lb/15 N·m.
10) Replace the removed parts in the reverse order of which they were removed.
If applicable, make sure the safety switch components are in position. See Fig. 3.
11) Move the flush/control switch to the "ICE" position. Plug the appliance into the electrical
outlet, then move the power switch to the "ON" position.
12) Replace the panels in their correct positions.
34