Unpacking (Dspdb-A1); Switches And Connector Locations; Installing The Dspdb-A1 Pcb - NEC Xen Topaz System Hardware Manual

September 2004
56 -

3.2 Unpacking (DSPDB-A1)

Unpack the DSPDB-A1 and check it against the following list. Inspect
for physical damage.
Items
DSPDB-A1

3.3 Switches and Connector Locations

• Make sure the Nylon-Spacers are inserted in each corner of the DSPDB-A1
PCB.
• The spacers must be attached from the back of the DSPDB-A1 PCB so
when installed, the CF slot is facing up.

3.4 Installing the DSPDB-A1 PCB

1. Open and pull out the Sub-Cover.
2. Loosen two screws and remove the Main-Cover.
NEC Business Solutions Ltd
List of Contents
DSPDB-A1 PCB
Nylon Spacers
CF (Compact Flash) Card
Installing the Optional Equipment
QTY
1
4
1 (mounted)