Ethernet Port Connector - Cisco CDE 220 Series Hardware Installation Manual

Appendix B Connector Pin Assignments
Table B-6
RJ-45 Pin
End 1
1
2
3
4
5
6
7
8

Ethernet Port Connector

The CDEs come with an integrated dual-port Ethernet controller. This controller provides an interface
for connecting to 10-Mbps, 100-Mbps, or 1000-Mbps networks; it provides full-duplex (FDX)
capability, which enables simultaneous transmission and reception of data on the Ethernet LAN.
To access the Ethernet port, connect a Category 3, 4, or 5 unshielded twisted-pair (UTP) cable to the
RJ-45 connector on the back of the device.
The 100BASE-TX/1000BASE-TX Ethernet standard requires that the cabling in the network be
Note
Category 5 or higher.
Figure B-3
Figure B-3
Activity LED
Fiber Connector Type
The fiber connector type used to connect to the SE dual-fiber NIC cards is the GLC-SX-MM.
RJ-45 Crossover Cable Pin Assignments for T568B
Wire Color
White/Orange
Orange
White/Green
Blue
White/Blue
Green
White/Brown
Brown
shows the pin number assignments for the Ethernet RJ-45 port.
RJ-45 Ethernet Port Connector
(green)
8
Cisco Content Delivery Engine 205/220/250/280/285/420/460/475 Hardware Installation Guide
Diagram End 1 RJ-45 Pin End 2
3
6
1
7
8
2
4
5
Speed LED
(green)
1
Fiber Connector Type
B-5