To Adjust The Position Of Thread Guide (3) - Janome 1110DX PRO Service Manual

Table of Contents

Advertisement

TO ADJUST THE POSITION OF THREAD GUIDE (3)

Thread Guide (3)
Loose the setscrew A, and adjust the thread guide (3) so that the hole of thread guide is in line with the groove
of lower looper as shown in Fig.1.
Thread Guide
Loosen the setscrew B and set the bottom side of external on the upper looper thread guide (Fig.2) and the
bottom side of external of the upper looper titubation arm C.
Tighten the setscrew B to secure the position.
The hole is in line with the groove of lower looper.
Thread guide (3)
View from A
Lower looper
A
Setscrew A
(Fig. 1)
ALIGNMENT
Looper thread guide
26
Upper looper driving arm
Setscrew B
(Fig. 2)

Advertisement

Table of Contents
loading

Table of Contents