To Adjust The Feed Dog Height - Janome 1110DX PRO Service Manual

TO ADJUST THE FEED DOG HEIGHT

Correct Setting:
When the presser foot is lowered and the feed dogs are at their highest position, the distance between the
surface of needle plate and bottom of presser foot should be 0.75 to 0.95 mm.
To adjust:
1. Set the stitch length dial at "3" and the differential feed dial at "1.0".
2. Lower the presser foot and raise the feed dogs to their highest position by turning the balance wheel.
3. Loosen the main & sub feed dog screws (4 pcs).
4. Push the main feed dog straight upward and adjust the distance between the surface of needle plate and
bottom of presser foot, then tighten the setscrews (2 pcs).
5. When the top of the main feed dog is level to the top surface of needle plate in its downward motion by
turning the balance wheel.
Loose setscrews for sub feed dog (2 pcs), and push the sub feed dog straight upward until its top surface
is to be level to the top surface of needle plate. Then tighten the setscrews of sub feed dog.
6. Check if these feed dogs are attached in parallel to the surface of needle plate while turning the balance
wheel.
Parallel to the surface of needle plate
Surface of needle plate
Push straight up
Push straight up
11