To Adjust The Feed Dog Height - Janome Memory Craft 3500 Servicing Manual

TO ADJUST THE FEED DOG HEIGHT

When pressure adjusting lever is at "3" and the presser foot is lowered, the highest
Position of the feed dog should be 0.75 to 0.85 mm from the surface of the needle
Plate.
1. Set the pressure adjusting lever at "3" with the presser foot lowered.
2. Turn on the power switch.
3. Turn the hand wheel toward you to get the highest position of feed dog.
4. Remove the bed cover.
5. Loosen the set screw (A) and nut.
6. Adjust the feed dog height to 0.75 mm to 0.85 mm by turning the adjusting screw (B).
7. Tighten the nut and set screw (A).
8. Attach the bet cover.
11