Hardware Bag Contents - Horizon Fitness ELITE E4000 Owner's Manual

ASSEMBLY Step 3
CONSOLE CABLE
NOTE: Be careful not to pinch any
wires while attaching the console
mast
CONSOLE MAST
PRE-INSTALLED BOLTS
PRE-INSTALLED
FLAT WASHERS
WAVY WASHER(G)
GUIDE RAIL SET
CRANK
PEDAL ARM
FLAT WASHER(H)
SPRING WASHER(B)
BOLT(I)
PEDAL ARM WHEEL
8
HarDWare BaG 3 CONTENTS
WAVY WASHER (G) FLAT WASHER (H) BOLT(I)
Φ17.2xΦ22.5xT0.5 Φ8.2xΦ20.0xT1.5 M8x20 mm
Qty:2 Qty: 2 Qty:2
SPRING WASHER (B)
Φ8.2xΦ15.4xT2.0
Qty:2
HARDWARE FOR STEP 3
A Open .
CONSOLE CABLE
B Carefully pull the through the
CONSOLE MAST
using the twist tie located inside
CONSOLE MAST
the .
CONSOLE MAST MAIN FRAME
C Attach to using
4 PRE-INSTALLED FLAT WASHERS 4
and
PRE-INSTALLED BOLTS .
WAVY WASHER (G) CRANK
d Silde over followed
PEDAL ARM PEDAL ARM WHEEL
by as shown. Rest
GUIDE RAIL SET
on .
PEDAL ARM CRANK 1 FLAT
E Attach the to using
WASHER (H) 1 SPRING WASHER (B)
, and
1 BOLT (I)
.
D-E
F Repeat steps on the opposite side of the elliptical.
ASSEMBLY Step 4
FLAT WASHER (J)
WAVY WASHER (K)
FLAT WASHER (J)
LOWER LINK ARM
PEDAL ARM BRACKET
BOLT (I)
SPRING WASHER (B)
FLAT WASHER (H)
HarDWare BaG 4 CONTENTS
FLAT WASHER(J) WAVY WASHER(K) BOLT (I)
Φ20.2xΦ27.2xT1.5 Φ20.7xΦ29.1xT0.5 M8x20mm
Qty:4 Qty:2 Qty:2
FLAT WASHER(H) SPRING WASHER (B)
Φ8.2xΦ20.0xT1.5 Φ8.2xΦ15.4xT2.0
Qty:2 Qty:2
Open HARDWARE FOR STEP 4.
A
Slide 1 FLAT WASHER (J), 1 WAVY WASHER
B
(K) and another 1 FLAT WASHER (J) onto the
LOWER LINK ARM.
Slide the LOWER LINK ARM into the PEDAL ARM
C
BRACKET.
Attach the LOWER LINK ARM to the PEDAL ARM
d
BRACKET using 1 FLAT WASHER (H), 1 SPRING
WASHER (B) and 1 BOLT (I).
Repeat steps B-D on the opposite side of the
E
elliptical.
9