Hardware Bag - Horizon Fitness ELLIPTICAL E1201 User Manual

ASSE MBLY STe P 1
A Open HArDWAre BAG FOr STeP 1.
B Attach the FrONT STABiLiZer TUBe to the mAiN FrAme using 2 BOLTS (A).
HArDWAre BAG FOr STeP 1 CONTeNTS :

E1201_Rev.1.4.indd 8-9
BOLTS (A)
MAIN FRAME FRONT STABILIZER TUBE
BOLT (A)
20 mm
Qty: 2
ASSEMBLY STeP 2
SPRING WASHERS (C) CONSOLE MAST
BOLTS (B) ARC WASHERS (E)
FLAT WASHERS (D)
CONSOLE MAST BOOT
CONSOLE CABLE MAIN FRAME
A Open HArDWAre BAG FOr STeP 2.
B Slide CONSOLe mAST BOOT onto the bottom of the CONSOLe mAST above bolt holes as shown above.
C Carefully pull the CONSOLe CABLe through the CONSOLe mAST using the twist tie located inside the
CONSOLe mAST.
D Attach the CONSOLe mAST to the mAiN FrAme using 2 BOLTS (B), 2 SPriNG WASHerS (C) and 2
FLAT WASHerS (D) in each side and 2 BOLTS (B), 2 SPriNG WASHerS (C) and 2 ArC WASHerS (e) in
the front of the CONSOLe mAST. Slide CONSOLe mAST BOOT down to cover mAiN FrAme.
DO NOT PiNCH WireS!
e Attach the WATer BOTTLe HOLDer to the mast using 2 Pre-ATTACHeD SCreWS.
HArDWAre BAG FOr STeP 2 CONTeNTS :
BOLT (B) SPRING WASHER (C)
15 mm 15 mm
Qty: 6 Qty: 6
CONSOLE
MAST
WATER
BOTTLE
BOLTS (B)
HOLDER
PRE-ATTACHED
SCREW
ARC
WASHER (E)
FLAT WASHER (D)
17 mm
18 mm
Qty: 2
Qty: 4
angle view

7/29/08 10:37:27 AM