Horizon Fitness ELITE E4000 Owner's Manual page 6

ASSEMBLY Step 5
CONSOLE MAST
RUBBER WASHER(L)
FLAT WASHER (M)
SPRING WASHER (B)
LOWER HANDLEBAR
10
HarDWare BaG 5 CONTENTS :
RUBBER WASHER(L) FLAT WASHER(M)
Φ16.2xΦ26.2x11.5T Φ16.0xΦ25.0x1.5T
Qty:2 Qty:4
FLAT WASHER(N) SPRING WASHER (B)
Φ8.6xΦ26.0x2.0T Φ8.2xΦ15.4x2.0T
Qty:4 Qty:2
Open HARDWARE FOR STEP 5.
A
B Slide 1 RUBBER WASHER (L) and 1 FLAT WASHER
(M) onto the CONSOLE MAST.
Slide LOWER HANDLEBAR onto CONSOLE
C
FLAT WASHER (N)
MAST and attach using 1 FLAT WASHER (M),
1 FLAT WASHER (N), 1 HANDLEBAR CAP, 1
FLAT WASHER (N), 1 SPRING WASHER (B)
and 1 BOLT (I).
Repeat steps B-C on the opposite side of the
d
elliptical.
BOLT (I)
ASSEMBLY Step 6
BOLT(I)
M8x20 mm
Qty:2
TEFLON WASHER (O)
LOWER LINK ARM
HarDWare BaG 6 CONTENTS :
TEFLON WASHER(O)
Φ15.9xΦ28.4x1.0T
Qty:4
SPRING WASHER (B)
Φ8.2xΦ15.4x2.0T
Qty:2
LOWER HANDLEBAR
Open HARDWARE FOR STEP 6. Remove zip tie
A
securing axle in LOWER LINK ARM.
NUT (R)
Align end of LOWER LINK ARM with bracket on
B
bottom of LOWER HANDLEBAR.
Place TEFLON WASHERS (O) on both sides of
C
the LOWER LINK ARM. While holding TEFLON
WASHER (O) slide LOWER LINK ARM into bottom
end of LOWER HANDBAR.
Secure the joint with 1 FLAT WASHER (P), 1
d
SPRING WASHER (B), 1 BOLT (Q) and secure
with 1 NUT (R).
Repeat steps B-D on the opposite side of the
E
elliptical.
FLAT WASHER (P)
SPRING WASHER (B)
BOLT (Q)
FLAT WASHER(P)
Φ8.4xΦ17.0x1.0T
Qty:2
BOLT(Q) NUT(R)
M8x70 mm M8X1.25P
Qty:2 Qty:2
11