Figure 2. 2230 SSD
Steps
1. Install the M.2 2230 SSD to the SSD bracket so that the top side of the SSD (with the sticker) is facing up.
2. Place the thermal plate on top of the SSD covering it completely.
3. Connect the SSD to the M.2 port on the system board and replace the single (M2x2) screw securing it to the system board.
Next steps
If you are replacing a component, remove the existing component before performing the installation procedure.
1. Reconnect the
battery
2. Install the
base
cover.
3. Follow the procedure in
Removing the 2280 Solid State Drive
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Disconnect the
battery
32
Disassembly and reassembly
cable.
After working inside your
computer.
Before working inside your
cable.
computer.