Panasonic PV-DF2702 Operating Instructions Manual page 15

portant: If a remote control button does not work when pressed, press the
on the remote and try the button again.
UTO CLOCK SET was incomplete, manually
the clock as follows.
Press ACTION on the Remote to
display SET CLOCK Menu screen.
SET CLOCK
1 / / 1 / /
SE SELE CT MONTH
SELECT :
SET :
SET
END : ACT I ON
Press to select the month
and press SE T set. In the same
manner, select and set the date,
year, time, and DST. (Daylight
Saving Time)
SET CLOCK
2 / 6/ 2002 WED 12 00PM PM
SET COMPLETED SE COMPLETED
SET : SET
START : ACT I ON
Press ACTION twice to start
CLOCK and exit.
:
DST : ON
:
DST : ON
BACK:
Reset all unit Memory Functions
When moving unit to a new location, or if a
mistake was made in the Initial Setup section.
• Make sure a tape is not inserted in the unit.
1 Turn the unit
Power on.
2 Press and hold both PLAY and
FF on the unit for more than 5
seconds.
• The power will shut off.
• Please ignore "NO CASSETTE" warning.
3
Do "Initial Setup" on page 14.
Note to CABLE System Installer
This reminder is provided to call the
CABLE (Cable TV) System Installers
attention to Article 820-40 of the NEC
that provides guidelines for proper
grounding and, in particular, specifies
that the cable ground shall be
connected to the grounding system of
the building, as close to the point of
cable entry as practical.
button