Running The Ibert Demonstration For Duals 101 And 123; Gtp Transceiver Clock Connections; Gtp Tx/Rx Connections - Xilinx SP623 Getting Started Manual

Running the IBERT Demonstration for Duals 101 and 123

Running the IBERT demonstration for Duals 101 and 123 is described in this section. See
also

GTP Transceiver Clock Connections

Refer to
SuperClock-2 module to the reference clock SMAs of GTP Duals 101 and 123 on the SP623
board. In other words, for each row in
corresponding destination SMA.
For example, connect CKOUT1_P (J5) to 101_REFCLK0_P (J59).
Table 1: Duals 101 and 123 Reference Clock Connections

GTP TX/RX Connections

Refer to
SMAs in GTP Duals 101 and 123. In other words, for each row in
transmitter SMA with its corresponding receiver SMA.
For example, connect 101_TX0_P (J53) to 101_RX0_P (J51) on the SP623 board.
Table 2: Duals 101 and 123 TX/RX Connections
SP623 IBERT Getting Started Guide
UG752 (v1.0.1) January 26, 2011
Running the IBERT Demonstration for Duals 245 and 267, page
Table 1 and use four SMA cables to connect the output clock SMAs from the
Source
SuperClock-2 Module
Net Name SMA Connector
CKOUT1_P
CKOUT1_N
CKOUT2_P
CKOUT2_N
Table 2 and use eight SMA cables to connect the transmitter SMAs to the receiver
Transmitter
Net Name SMA Connector
101_TX0_P
101_TX0_N
101_TX1_P
101_TX1_N
123_TX0_P
123_TX0_N
123_TX1_P
123_TX1_N
www.xilinx.com
Table 1, connect the source SMA with its
Net Name
J5 101_REFCLK0_P
J6 101_REFCLK0_N
J7 123_REFCLK0_P
J8 123_REFCLK0_N
Net Name
J53 101_RX0_P
J54 101_RX0_N
J57 101_RX1_P
J58 101_RX1_N
J67 123_RX0_P
J66 123_RX0_N
J63 123_RX1_P
J62 123_RX1_N
Procedure
18.
Destination
SP623 Board
SMA Connector
J59
J60
J70
J61
Table 2, connect the
Receiver
SMA Connector
J51
J52
J55
J56
J68
J69
J65
J64
9