Procedure; Extracting The Ibert Demonstration Files - Xilinx SP623 Getting Started Manual

Procedure

•
•
Caution!
ESD prevention measures when handling the board.
Procedure

Extracting the IBERT Demonstration Files

The ChipScope Pro Analyzer .cpj project files for the IBERT demonstration are located on
the CompactFlash memory card that is provided with the SP623 board. The project files are
used to load pre-saved MGT/IBERT and clock module control settings for the
demonstration. These files must be copied from the CompactFlash memory card to a
working directory on the host PC. To copy the project files:
1.
2.
X-Ref Target - Figure 1
3.
6
CompactFlash PCMCIA adapter card
Xilinx® ChipScope™ Pro analyzer software, version 11.4 or higher.
Software is available at: http://www.xilinx.com/chipscopepro
The SP623 board can be damaged by electrostatic discharge (ESD). Follow standard
Connect the CompactFlash memory card to the host computer.
Note:
The CompactFlash memory card can be plugged into the host PC PCMCIA interface
using a PCMCIA adapter card.
Use Windows Explorer to locate sp623.zip on the Compact Flash memory card. The
ZIP file content is similar to the files shown in
Figure 1: ChipScope Software Project Files Included in the sp623.zip File
Unzip the files to a working directory on the host PC.
www.xilinx.com
Figure 1.
SP623 IBERT Getting Started Guide
UG752 (v1.0.1) January 26, 2011
UG752_01_052410