Chapter 5: Card Bring-Up And Validation; Environment Setup; Running Lspci - Xilinx VCK5000 Installation Manual

Card Bring-Up and Validation
After installing the XRT and deployment platform, the card installation can be verified using the
following commands, which are explained in more detail below.
• lspci
• xbmgmt examine
• xbutil validate
• xbutil examine
The lspci Linux command is used to confirm the card is seen by the OS.
The additional commands are used to validate and identify the installed card(s) and report
additional card details including thermal and electrical status, memory, PCIe
and system information. See

Environment Setup

Set the environment to use the utilities by running the following command. Note that the
command is dependent on the command shell you are using.
Use the following command in csh shell:
$ source /opt/xilinx/xrt/setup.csh
Use the following command in bash shell:
$ source /opt/xilinx/xrt/setup.sh

Running lspci

1. Enter the following command:
$ sudo lspci -vd 10ee:
UG1531 (v1.0) March 4, 2022
VCK5000 Hardware Install Guide
xbutil and xbmgmt.

Chapter 5: Card Bring-Up and Validation

Chapter 5
® , platform name,
www.xilinx.com
Send Feedback
21