Running The Video Demonstration - Xilinx KC705 Getting Started

Chapter 1: Getting Started with the Kintex-7 FPGA KC705 Embedded Kit
Video Demonstration Hardware Setup Instructions
1.
2.
X-Ref Target - Figure 1-2
Ethernet
Figure 1-2: Kintex-7 FPGA Video Demonstration Hardware Setup
3.
Note:
and does not connect to the regular LAN network using DHCP. Do not connect more than one board
to the same network segment.

Running the Video Demonstration

To run the video demonstration, copy and unzip the demonstration package files either
from the USB flash drive or from the Web to the host machine and follow these steps:
1.
2.
8
This demonstration requires default switch and jumper settings on the KC705 board.
For more information on the default switch settings, refer to the "Hardware Test Board
Setup Requirements" section of UG883, Kintex-7 FPGA KC705 Evaluation Kit Getting
Started Guide.
Connect the KC705 board, HDMI cables, display monitor, Ethernet cable, and USB
cables as shown in Figure
UART
JTAG
HDMI_OUT
1080P
Set the IP address of the host PC to 192.168.1.100. Return the IP address of the PC back
to its original setting after running the demonstration.
The demonstration uses a hard-coded MAC address and a fixed IP address of 192.168.1.10
If the KC705 board is not already powered on, plug in the power adapter to local AC
power. Plug the 12V power cable into the board connector on J49. Turn on the power
by switching the SW15 to the ON position.
Open and configure a serial communications terminal utility program with these
settings:
• Baud Rate: 9600
• Data: 8 bit
www.xilinx.com
1-2.
KC705 Evaluation
Board
POWER
SUPPLY
UG913_c1_02_051612
KC705 Getting Started Guide
UG913 (v1.0.1) May 31, 2012