Snmpv3 - Xerox B210 User Manual

Enabling SNMP Using Xerox
1. In Xerox CentreWare
®
2. Click SNMP.
3. For Protocol, select Enable.
4. To configure the SNMP properties, for Edit SNMP Properties, click Edit.
5. For Community Names, enter the GET and SET community names.
For Default TRAP Community Name, type a name.
6.
7. For Authentication Failure Generic Traps, to generate a trap for every SNMP request received by
the printer which contains an invalid community name, click Enable.
Click Apply.
8.
Configuring SNMP Trap Destination Address Using Xerox
Internet Services
You can add, edit, or delete IP addresses for Network Management workstations that receive traps
from the device.
1. In Xerox CentreWare
®
Click SNMP.
2.
3. In the Trap Destination Address section, click Add IP Address.
4. For IP Trap Destination Address, type the IP address of the host running the SNMP manager that
receives traps.
5. Type the UDP Port Number.
6. To add the traps, perform the following steps.
• For TRAP Community Name, type a name.
• For Traps to be Received, select the type of traps that the SNMP manager receives.
Click Apply.
7.

SNMPv3

SNMPv3 is the current standard version of SNMP defined by the Internet Engineering Task Force
(IETF). It provides three important security features:
• Message integrity to ensure that a packet has not been tampered with in transit
• Authentication to verify that the message is from a valid source
• Encryption of packets to prevent unauthorized access
Note: When configuring settings in Properties, you will be prompted to enter the Administrator
account user name and password. For information about logging in as an administrator, refer to
Accessing the Xerox® CentreWare® Internet Services Administrator
CentreWare
®
Internet Services, click Properties
®
Internet Services, click Properties
®
Internet Services
®
Connectivity Protocols.
 
®
Connectivity Protocols.
 
Account.
Xerox
Network Connectivity
CentreWare
®
52
B210 Printer
®
User Guide