Figure 38 Remove Four Screws; Figure 39 Re-Install Filter Support Brackets Into Lower Slots; Figure 40 Re-Install Screws And Bend Tabs Up; Figure 41 Install Right 2" Filter - Bard MULTI-TEC W42ACE Series Service Instructions Manual

2. Locate the filter support brackets and remove the
four (4) screws holding them to the top of the
control panel (see Figure 38).
FIGURE 38
Remove Four Screws
3. Pull the brackets out towards the front of the unit.
The back of the bracket will slip out of the upper
slots at the back of the filter tray.
4. Re-install the filter support brackets into the lower
slots at the back of the filter tray (see Figure 39).
FIGURE 39
Re-Install Filter Support Brackets into Lower Slots
Upper slots for
1" filters
Lower slots for
2" filters
5. Re-install the four (4) screws into the upper screw
holes on the filter support brackets. Then bend the
tab up out of the way (see Figure 40).
FIGURE 40
Re-Install Screws and Bend Tabs Up
Manual 2100-725C
Page 30 of 39
6. Install the right 2" filter first followed by the left
filter (see Figures 41 and 42).
NOTE: When installing new filters, make sure that
airflow arrows on filters point up.
7. Reverse the steps above to switch from 2" to 1"
filters.
FIGURE 41
Install Right 2" Filter
FIGURE 42
Install Left 2" Filter