Audible Signals; Setting The Clock - Whirlpool MH6700XW Use & Care Manual

Number Pads
Fan and light Pads
The six pads at the bottom of the control panel
control the 2-Speed Exhaust Fan and the Cook-
top Light.
Touch Fan Pad for the desired fan speed.
(NOTE: If the temperature gets too hot
around the microwave oven, the ex-
Once you've touched a Command Pad to tell
the oven what you want it to do, you'll touch
Number Pads to tell it...
- a time.
- a Cook Power.
- a food temperature.
haust fan in the vent hood will
automatically turn on the LOW setting to
protect the oven. It may stay on up to an
hour to cool the oven. When this occurs,
the Fan Pad will not turn the fan off.)
Touch Light Pad for the desired cooktop or
countertop lighting.
Audible Signals
Audible signals are available to guide you when setting and using your oven. (A programming tone will
sound each time you touch a pad. Two beeps will sound between cycles. A reminder tone will sound every
60 seconds after cooking is done to remind you that something has been left in the oven. A 3 second tone
signals the end of the Minute Timer function.) If you don't hear a tone, it is because of incorrectly entered
instructions or because the tones have been removed. For example, a tone will not sound if you touch a
Number Pad before you touch a Command Pad.
To remove the programmlng tone
and reminder
To
remove all tones, except
the Mlnute
Tlmer
tone:
slgnal:
* Open the door. * Open the door.
* Touch CANCEL twice, then touch START. 0 Touch CANCEL twice, touch 0, then touch START.
4 Programming and reminder tones will be
d All audible tones (including Minute Timer
cancelled.
signal) will be cancelled.
To replace the tones:
To replace the tones:
7 Repeat the steps above.
* Repeat the steps above.
NOTE:
If your electrlclty goes off, the tones will be replaced when the electrlctty comes
back on.
Setting the Clock
When the oven is first plugged in, a tone sounds and the Display shows "88:88:' If the
electric power ever goes off, the Display will again show all 8's when the power comes
back on.
You can cook or use the Minute Timer without setting the Clock, but the Display will be
blank after cooking.
DO THIS...
THIS HAPPENS...
.
Hi3
1. Touch CLOCK Sm.
The Display will show a "0" and the
colon will start to flash. The flrst
Number
Pad must be touched wlthln
5 seconds or the Display will go
blank. If this happens, touch CLOCK
SET again and continue.