Table of Contents
Advertisement
Audible signals
Audible
signals are available
to guide
you when setting and using your oven. (A programming
tone will
sound each time you touch a pad. Two beeps will sound between
cycles. A reminder
tone will sound
every 30 seconds
after cooking
is done to remind you that something
has been left in the oven. A
3 second
tone signals the end of the Minute Timer function.]
If you don't hear a tone, it is because
of
incorrectly
entered
instructions
or because
the tones have been removed.
For example,
a tone will not
sound if you touch a Number
Pad before you touch a Command
Pad.
To remove the programming
tone and reminder
To remove ail tones, except
the Minute Timer
tone:
signal:
l
Open the door.
l
Open the door.
l
Touch CANCEL
twice,
then touch START.
l
Touch CANCEL
twice,
touch 0, then touch START.
l
Programming
and
reminder
tones
will
be
l
All audible
tones (except
Minute
Timer signal)
cancelled.
will be cancelled.
To replace the tones:
To replace the tones:
l
Repeat
the steps above.
l
Repeat
the steps above.
NOTE: it your electricity
goes off, the audible
signals will come back on. Repeat steps
above if you want to remove them again.
Setting the clock
When the oven Is first plugged
in, one beep will sound and the Display
shows 88:88. If the
electric
power
ever goes off, the Display
will again
show all B's when the power comes
back on.
You can cook without setting the clock, but the Display
will be blank after cooking.
DO THIS...
THIS HAPPENS...
The Display
will show a "0" and
the colon will start to flash.
The
tirst Number Pad must be touched
within 5 seconds or the Display will
go blank.
Touch CLOCK SET again
and continue.
2. Touch Number Pads for the
correct time of day.
The Display
will show what numbers
you touched
in the order you
touched them.
This example
shows
3:25.
3.
Touch START.
The colon will stop flashing. The Clock
is set.
If you have touched
in an incorrect
time, such as 12:65, "Err" will show on
the Display. Touch CLOCK SET and
start over.
NOTE: To reset the clock, touch CLOCK SET. The current time will show on the Display
and the colon will flash. Continue to set the clock as shown above.
6
Advertisement
Table of Contents
