Table of Contents
Advertisement
Uslng Your Microwave
Oven
Continued
Audible signals
Audible signals are available to guide you when
setting and using your oven. A programming
tone will sound each time you touch a pad. Two
beeps will sound between cycles. A reminder
tone will sound every 30 seconds after cooking is
done to remind you that something has been left
in the oven. Four beeps signal the end of the
Minute Timer function and a Cook or Defrost
cycle. If you don't hear a tone, it is because of
incorrectly entered instructions
or because the
tones have been removed. For example, a tone
will not sound if you touch a Number Pad before
you touch a Command Pad.
To remove the programming
tone:
1. Open the door.
2. Touch CANCEL twice, then touch START.
3. Programming
and reminder tones will be
cancelled.
To replace the tones:
l
Repeat the steps above.
To remove all tones:
1. Open the door.
2. Touch CANCEL twice, touch 0, then touch
START.
3. All audible tones (including Minute Timer signal)
will be cancelled.
NOTE: Do not remove all tones if you use the
Minute Timer.
To replace the tones:
l
Repeat the steps above.
NOTE: If your electricity goes off, the audible
signals will come back on. Repeat steps above if
you want to remove them again.
Setting the clock
When the oven is first plugged in, a tone sounds
and the Display shows E&88. If the electric power
ever goes off, the Display will again show all 8's
when the power comes back on.
You can cook without setting the clock, but the
Display will be blank after cooking.
1. To set the clock, touch CLOCK SET. The
Display will show a "0" and the colon will
start to flash. The first Number Pad must be
touched
within 5 seconds
or the Display
will go blank. If the Display goes blank,
touch CLOCK SET again and continue.
10
Advertisement
Table of Contents
