Delivery Measures; Installing Wheel Weights; Refilling Battery Acid; Fastening Steering Wheel - Husqvarna Rider 18 ProFlex Workshop Manual

Installing wheel weights, Rider 20 ProFlex
Wheel weights are supplied with the Rider 20
ProFlex; these should be installed by the dealer.

Refilling battery acid

The battery is delivered dry from the factory.
• Slowly fill the battery acid up to the mark on the
battery.
• Wait 20 minutes and fill, as is required, with more
battery acid.
• Charge the battery (12 V, 6 A) for four hours.
• Check the level of acid and fill, as is required,
with distilled water up to the correct level.
!
WARNING!
The battery acid is highly corrosive. Use
rubber gloves and protective glasses. Avoid
breathing in the acid fumes.
Measures for contact with acid
External: Rinse thoroughly with water.
Internal: Drink large quantities of water or
milk. Contact a doctor as soon as
possible.
Eyes: Rinse thoroughly with water.
Contact a doctor as soon asap.
The battery gives off explosive gas. Sparks,
naked flames and cigarettes must absolutely
not be in the near vicinity of the battery.
10
– English

Delivery measures

Fastening steering wheel

• Fasten the steering wheel with steering column
• Tighten the socket head cap screw, make sure
• Securely lock the socket head cap screw with the

Fastening support wheels

Fasten the support wheels with axles, spacers and
nuts in the support wheels holder.

Installing tow hitch

The tow hitch is supplied separately with the Rider.
This should be fitted by the dealer.
on the steering shaft.
that it sits in its groove on the steering shaft.
locking nut.