Refitting hydrostatic transmission wire
Screw the front ball joint onto the new transmission
wire and tighten the lock nut.
2
Run the wire through the mower so that it follows
the same route as the old wire.
3
Push the linkage into the front slot in the tunnel.
4
Bolt the transmission wire-retaining clip back in
place. Press the ball joint onto its ball and refit the
wire clip.
5
Screw the ball joint onto the lower end of the
transmission wire. Tighten it 10–12 turns so that the
linkage is the correct length.
Reparation instructions
37
English –