Handle - Husqvarna K 960 Workshop Manual

HANDLE

Rear handle
Lock the throttle against
unintentional activation
Faulty function must be rectified.
The machine must be split
at the vibration dampening
element to perform service work
on the control.
Dismantling
The throttle and throttle lock
are both located in the handle
by a 3 mm spindle. Press out the
spindles to the right.
Assembly
Fit the throttle first. Make sure
that the spring comes out by the
throttle lock.
Assemble the spindle from
the right-hand side.
The spring should lie on the
right-hand side (clutch side) of
the throttle lock pin. Lower the
control parallel with the handle.
Assemble the spindle from
the right-hand side.
Rear handle
Lock the throttle against uninten-
tional activation
Check the function of the lock. The
throttle should be locked in idling mode.
Not until the lock on top of the handle
is pressed in should the throttle be re -
leased. Faulty function must be rectified.
The machine must be split at the
vibration dampening element to perform
service work on the control.
Dismantling
The throttle and throttle lock are both
located in the handle by a 3 mm spindle.
The spindles sit with a press fit towards
the left-hand side and must therefore be
pressed out to the right-hand side and
pressed in from the same side when
assembling.
Assembly
Fit the throttle first. Insert the control in
the handle and make sure that the spring
comes out by the throttle lock.
Assemble the spindle from the right-
hand side.
Note the position of the spring in the
throttle.
The spring should lie on the right-hand
side (clutch side) of the throttle lock pin.
Place the spring in the throttle lock and
lower it parallel with the handle.
Assemble the spindle from the right-
hand side.
18
51