Husqvarna K 960 Workshop Manual page 8

DISMANTLING INTO BASIC MODULES
6
7
Assembly
6. Pre-assemble the components as
illustrated. Slide the screws slightly past
the contact face.
7. Note the partition wall in the inlet
manifold. Note that the marking "UP"
must face upwards, if the partition wall
was loosened when dismantling the car-
burettor.
Inlet manifold
Dismantle the entire air filter unit,
cylinder cover, starter, air duct and car-
burettor.
The cylinder must be lifted slightly to
replace the inlet manifold between the
carburettor and cylinder. See the detailed
description on page 21.
Air duct
Dismantle the entire air filter unit,
cylinder cover and starter.
Note how the cable to the stop switch
and the ignition lead are fitted in the air
duct.
Loosen the ignition lead from the
spark plug and release the cable from the
air duct.
Loosen the cable lug on the ignition
module and the stop switch. Remove the
air duct.
Inlet nozzle
There are two flywheel positions where
the screws become accessible. Dismantle
the screw and pull out the nozzle.
Muffler
Dismantle the cutting head, air filter and
cylinder cover.
The muffler is secured by three screws.
Dismantle these and remove the muffler.
Assembly
The insulated fibre gasket should lie
against the muffler.
The heat shield should lie closest to the
cylinder.
4
7