Husqvarna K 960 Workshop Manual page 37

14
1
1
1
36
CRANKCASE
504 91 40-01 505 38 17-23
2
2
2
502 50 82-01
3
3
Crankcase seals
Tools
The puller 504 91 40-01, assembly taper
505 38 17-23 and the assembly punch
502 50 82-01 are needed to change the
crankcase sealing rings.
Dismantling
1. Press down the puller and tighten the
puller's conical thread in the seal ing ring.
2. Pull up the sealing ring by screwing in
the tool's centre bolt (T- handle).
Repeat the procedure on the fly wheel
side.
Assembly
CLUTCH SIDE
1. Lubricate the assembly taper and place
on the axle.
2. Press down the sealing ring over the
taper and down towards the seat ing.
3. Knock down the sealing ring into its
seating with the assembly punch.
Assembly
FLYWHEEL SIDE
1. Lubricate the axle. (The assembly taper
is not used.)
2. Press the sealing ring against the
seating.
3. Knock down the sealing ring into its
seating with the assembly punch.
Wipe off the grease on the axle before
the flywheel is fitted.
Pressure test
Pressure test the crankcase. Check the
seals crankshaft/sealing ring and sealing
ring/crankcase with leakage spray or
soapy water.