Husqvarna K 960 Workshop Manual page 20

8
9 10
1
INLET SYSTEM
Assembly
8. Important when reassembly:
Screw the clamp together com-
pletely in against the spacer
tube.
Alternative dismantling procedure
Instead of dismantling the inlet bend together with the carburettor first and
then the inlet manifold, it is often practical to dismantle the entire unit from
the cylinder. The actions to be performed on the machine determine the
procedure to follow.
The entire unit is dismantled as follows: Dismantle the two screws for the
inlet manifold's holder and the screw for the inlet bend's holder. Now lift the
cylinder slightly and place the support plate under it. Loosen the clamp
around the inlet manifold and pull this off of the cylinder.
Replacing the rubber
bellows
9. Dismantle the partition wall.
10. Press the rubber bellows out
of the holder and dismantle the
metal plate.
Parts must face the right
way!
Correct assembly is evident
from the pictures.
Inlet bend
The inlet bend leads air from the filter unit to the carburettor.
The duct, marked with arrows, connects the carburettor's measurement
chamber with the intake air. The pressure equalisation between these results in
the carburettor giving the correct fuel/air mixture irrespective of how much
the filter is clogged. This is the operating principle of the SmartCarb™.
IMPORTANT
It is extremely important that the inlet bend seals perfectly against the
carburettor and cylinder cover.
2 3
Assembly
8. It is important that the clamp is
screwed together completely in against
the spacer tube in order for the inlet
manifold to seal fully against the cylin-
der.
Replacing the rubber bellows
9. Dismantle the partition wall in the
inlet manifold first.
10. Press the rubber bellows out of the
holder and dismantle the metal plate.
Parts must face the right way!
Correct assembly of the components is
evident from the pictures.
Make a special check to ensure the
impulse channel is open.
Replacing the inlet bend
Press the inlet bend out of the holder.
Exercise extreme care when assembling
the new rubber bend in the holder.
The assembly method is evident from the
order of pictures 1, 2 and 3.
9
19