Husqvarna K 960 Workshop Manual page 48

1
2
CUTTING HEAD
3x
Assembling the inner bearing
Place the bearing on the support plate
and hold it under the bearing housing.
Insert the screw through the washer on
the upper side and assemble the screw in
the support plate on the underside.
Lock the screw and turn the nut until
the bearing reaches the stop in the bearing
housing.
Assembling the outer bearing
Position the bearing and spacer on
the support plate and hold it under the
bearing housing.
Note the position of the triangle! The
triangle should be directly but ted up to
the bearing fitted first.
Pull in the outer bearing until the spacer
ring touches.
1. Assembling the axle
First check that the spacer ring between
the bearings is centred.
The following procedure gives good
results:
Turn the triangle with the smooth side
facing downwards. Hold the axle on its
underside and screw in the screw of the
tool along with the large washer.
Note that the triangle lies directly
against the bearing fitted first.
Pull the axle in until it bottoms
against the flat underside of the triangle.
2. Adjusting the axle level
The axle must be adjusted upwards to
just under 3 mm from the level of the
bearing, in other words from the level
resulting from stage 1.
Fit the triangle with the convex side
facing downwards. Tighten the nut by
three turns.
16
47