Husqvarna K 960 Workshop Manual page 7

4
1
3
1
1
b
a
2 3
4
6
DISMANTLING INTO BASIC MODULES
2
2
c
5
Air filter
1. Loosen both screws on the guard and
remove the guard.
2. Lift off the filter base.
3. Carefully lift up the paper filter so
that dust does not fall down into the
inlet bend.
Cylinder cover
1. Loosen the three screws on the
cylinder cover.
2. Lift off the cylinder cover.
Carburettor
1a. Dismantle the choke control by
turning it to the side and removing it
from its bracket.
1b. Removed the throttle rod from the
throttle and dismantle from the carbu-
rettor.
1c. Pull off the fuel hose from the carbu-
rettor.
2. Remove the first screw holding the
carburettor on the crankcase.
3. Now insert the Torx key through the
hole in the handle and loosen both
screws holding the carburettor on the
inlet manifold.
4. Remove the screws at least 10 mm.
Pull the carburettor slightly backwards, it
can now be lifted upwards.
5. Remove the guide for the carburettor
setting from the machine.