Husqvarna K 960 Workshop Manual page 17

7
18–22 lbf·ft/25–30 Nm
16
FLYWHEEL
Check the keyway and key
Note that the key in the fly -
wheel is cast and can not be
replaced. If the key is damaged
the flywheel must be replaced.
Fit the flywheel
The crankshaft and the centre of
the flywheel must be free from
grease when assembling.
Tightening torque
18–22 lbf·ft/25–30 Nm
Use a torque wrench to tighten
the nut.
Check the keyway and key
Note that the key in the flywheel is cast
and can not be replaced. If the key is
damaged the flywheel must be replaced.
As the ignition point is determined by
the position of the flywheel on the crank -
shaft, components must have exactly the
right placement in relation to each other.
Only the force of the centre nut is not
sufficient to hold the flywheel in the
right position.
Fit the flywheel
The crankshaft and the centre of the
flywheel must be free from grease when
assembling.
Align the key in the flywheel with the
keyway on the crankshaft. Fit the washer
and centre nut.
Tightening torque
18–22 lbf·ft/25–30 Nm
Use a torque wrench to tighten the centre
nut.