Handle - Husqvarna K 750 Workshop Manual

HANDLE

Rear handle
Throttle trigger lock
Check the function of the lock.
Faulty function must be rectified.
The carburettor unit must be
dismantled to carry out a service
on the controls.
Dismantling
The throttle and throttle lock
are both located in the handle by
a 3 mm spindle. The spindles
must be pressed out to the right-
hand side and pressed in from
the same side when assembling.
Dismantle the starter.
Use a round rod with a diameter
of .08–.01 in./2–2.5 mm and
approximately 4 in./ 10 cm in
length to drive out the spindles.
Note how the controls' springs
are fitted.
Rear handle
Throttle trigger lock
Check the function of the lock. The
throttle should be locked in idling mode.
Not until the lock on top of the handle is
pressed in should the throttle be released.
Faulty function must be rectified.
The carburettor unit must be dismant-
led to carry out a service on the controls.
Dismantling
The throttle and throttle lock are both
located in the handle by a 3 mm spindle.
The axles sits with the press fit towards
the left-hand side and must therefore be
pressed out to the right-hand side and
pressed in from the same side when
assembling.
Dismantle the starter.
Drive mandrels with dimensions under
3 mm are usually too short for dismant-
ling the throttle spindle. Use a round rod
instead with a diameter of .08–.01 in./
2–2.5 mm and approximately 4 in./10 cm
in length.
Note how the controls' springs are fitted
if these are to be replaced.
Assembly
Fit the throttle first. Insert the control
from the carburettor compartment and
make sure that the spring comes out
through the handle. Assemble the axle
from the right-hand side.
The spring should lie on the right-hand
side (clutch side) of the throttle lock pin.
Place the spring in the throttle lock and
lower it parallel with the handle.
Assemble the axle from the right-hand
side
The picture to the right shows the
assembly from the carburettor compart-
ment.
17
51