Cisco WLC 5700 Series Command Reference Manual page 39

Layer 2/3 Commands
Examples
This example shows how to configure the LACP port priority on a port:
Controller# interface gigabitethernet2/0/1
Controller(config-if)# lacp port-priority 1000
You can verify your settings by entering the show lacp [channel-group-number] internal privileged EXEC
command.
Related Commands
Command
channel-group
lacp system-priority
show lacp
OL-32323-01
Description
Assigns an Ethernet port to an EtherChannel group, or enables an
EtherChannel mode, or both.
Configures the LACP system priority.
Displays LACP channel-group information.
Layer 2/3 Command Reference, Cisco IOS XE Release 3E (Cisco WLC 5700 Series)
lacp port-priority
31