DURKOPP ADLER D867 Additional Instructions page 12

Fig. 7: Assembling the NSB into the machine (2)
(1) - Screws
9. Manually turn the needle to top dead center.
10. Extend the thread-pulling knife (2) by hand without pressure as far as
11. Lower the needle by turning the handwheel
 The needle must be positioned in the center of the needle hole of
12. Loosen the screws (1).
13. Move the entire NSB unit such that the needle is positioned precisely
14. Tighten the screws (1).
15. Raise the needle by turning the handwheel.
16. Slide the thread-pulling knife (2) all the way back.
10
①
it will go.
the thread-pulling knife (2).
Make sure the thread-pulling knife (2) remains fully extended.
in the center of the needle hole of the thread-pulling knife (2) (see figure
above).
When doing so, make sure that you do not move the NSB unit.
Assembling the neat seam beginning (NSB)
(2) - Thread-pulling knife
Additional Instructions M-TYPE DELTA - 00.0 - 05/2020
②