Table of Contents
Advertisement
TLP Pro 1225, 1525, and 1725 Series Rear Panel Features
Figure 4 shows the TLP Pro 1225MG rear panel. The TLP Pro 1525MG and 1725MG are very
similar.
A
B
C
D
E
F
Figure 4.
A
B
C
D
E
F
G
H
I
RESET
MENU
1
2
TLP Pro 1225MG Rear Panel
Mounting plate notches (2) — Fit over the hooks at the top of the mounting plate (see
Wall Mounting
on page 28).
Reset LED — Provides feedback about the reset status when the user presses the reset
button.
Reset button — Pressing the
different modes (see
Reset Modes
Menu button — Activates the setup menu (see
USB connectors (2) — For peripheral controls.
Mounting screw slot (2) — Insert the provided screws here. Secure the touchpanel to the
mounting plate (see
Wall
Mounting).
Audio output — For use with headphones or assistive listening devices.
HDMI input — For alternative video input.
XTP/LAN/PoE input — The TLP Pro 1725MG ships with the Extron PI 140 power injector
provided. For the TLP Pro 1225MG or 1525MG, a power injector must be purchased
separately.
•
XTP input — Connect the touchpanel to the XTP source using a twisted pair cable,
terminated with an RJ-45 connector. For complete information about which cables to
use, see the user guide for your XTP product.
LAN input — Connect the touchpanel to the LAN using a twisted pair cable, terminated
•
with an RJ-45 connector.
PoE input — the connector can be used with a PoE power injector (see
•
Ethernet
on page 11).
NOTE:
Some XTP models are able to remotely power these touchpanels but not
all have that capability. Go to the
for your XTP model to ensure it can power your touchpanel.
An Extron IP Link Pro control processor must also be connected to the same network as the
TouchLink Pro touchpanel.
TLP Pro 1225, 1525, and 1725 Series • Panel Features
HDMI IN
XTP /
LAN /
PoE
Reset button allows the unit to be reset in any of four
on page 34).
Setup Menu
Extron website
A
G
H
I
on page 14).
Power over
and check the product page
8
Advertisement
Table of Contents
