Start Up Sheet - Johnson Controls TM9V C Series Installation Manual

Two stage variable speed ecm residential gas furnaces
Table of Contents

Advertisement

SECTION XIII: START UP SHEET
Start-Up Date
Technician Performing Start-Up
Owner Information
Name
City
Equipment Data
Furnace Model
Indoor Coil Model
Outdoor Unit Model
Furnace Configuration
Upflow
Downflow
Filter, Thermostat, Accessories
Filter Type
Thermostat Type
Connections -- All Per Installation Instructions and Local Code
Unit is level or tilted slightly forward
Vent system is connected
Condensate Management
Condensate tubing is correctly installed for the furnace position
Venting
Intake Size
# of 90 Degree Ells
Exhaust Size
# of 90 Degree Ells
Venting system is the proper size, within the limitations of the chart in the installation
instructions, properly connected to the furnace, and properly pitched
Electrical: Line Voltage
Polarity is correct (black is L1 (hot), white is N (neutral)
Line voltage value to furnace (volts AC)
Electrical: Low Voltage
Thermostat wiring is complete
Low voltage value between "R" and "C" on furnace control board (volts AC)
Staging:
Thermostat Staging:
Johnson Controls Ducted Systems
Proper furnace start up is critical to customer comfort and equipment longevity
State or Province
Horizontal Left
Filter Size
Other System Equipment and Accessories
Gas piping is connected (including drip leg)
Supply plenum and return air are connected
# of 45 Degree Ells
# of 45 Degree Ells
Thermostat heat anticipator set to .4 or (6 cycles per hour for electronic thermostats)
OFF
10 MIN
15 AUTO
Installing Contractor Name
Address
Furnace Serial
Indoor Coil Serial
Outdoor Unit Serial
Horizontal Right
Filter Location(s)
Condensate drain is connected
Length
Length
Ground wire is connected from the furnace to electrical panel
20 MIN
5750149-UIM-D-1219
Zip or Postal Code
Exhaust
Termination
Intake
Termination
Continued on next Page
Roof
Sidewall
Roof
Sidewall
Attic
41

Advertisement

Table of Contents
loading

Table of Contents