Table of Contents
Advertisement
To set up the Pro-Stitcher carriage
1. Place the Pro-Stitcher carriage on the frame system with the connectors toward the back of the
frame. Carefully lift the quilting machine and place it on the carriage so the wheels engage the white
carriage tracks, making sure not to set the wheels on top of the stitch regulator cable. This is easier to
do with two people, one at each end of the quilting machine.
2. With one end of the stitch-regulator
cable plugged into the machine's C-Pod
and the middle connector plugged
into the quilting machine's Y-encoder,
plug the other end of the cable into
the carriage X-encoder. Attach harness
cable.
3. Attach one end of the harness cable (see
Parts List, item P) into the connector
on the right side of the power supply.
Tighten the side screws. You will plug
the other ends to the bracket as part
of step 5 when you attach the tablet
computer.
4. Connect one end of the 12-foot power cord (see
Parts List, item I) to the carriage power inlet and
the other end into a wall receptacle when the
Pro-Stitcher setup is complete. Do not plug into
the wall at this time.
www.Janome.com
Installation Instructions | 15
Hide quick links:
Advertisement
Table of Contents
